Gude expert net control 2101/2151, Руководство пользователя

Страница: 19 / 23

19
expert net control 2101/2151 Features
6 Features
6.1
Bootloader mode
To activate the bootloader mode of expert net control 2101/2151 the select button must be pushed while restarting the
device. In bootloader mode it is possible to disable the password protection, to update the firmware and to restore the default
settings by running the program GBL_Conf.exe.
If the device runs already, press the buttons "select" and "ok" for three seconds. The bootloader mode of expert net control
2101/2151 is indicated by “BOOT-LDR” appended to the device name in the program window of GBL_Conf.exe.
During bootloader mode an alteration of the relais is not possible.
To restart the firmware, without toggle the Power Ports, press the buttons select and ok for three seconds again.
6.2
Firmware update
In order to update the firmware the program GBL_Conf.exe and the latest firmware are needed.
Start the device in bootloader mode and run the program GBL_Conf.exe. On the left side of the program window all Gude
devices that are in the network are listed. Select the device, that should be updated, click on Program DeviceFirmware
Update and determine the location of the new firmware.
Please note: The up-to-date firmware and GBL_Conf.exe can be found at www.gude.info, free to download.
6.3
Technical information
Connections: 1 x Ethernet jack (RJ45)
2 x Connector for sensors (RJ45)
1 x Terminal clamp Output
1 x Connector for power supply unit
Networkg: 10/100 MBit/s 10baseT Ethernet
Protocols: TCP/IP, HTTP,
SNMP v1 und v2c, SNMP traps, Syslog
Output: 0,5A 60V AC / 0,5A 30V DC
Input: 7,5-12V DC, 0,5A
Power supply: Power supply unit or Power over Ethernet (expert net control 2151)
Operating temperature: 0°C-50°C
Dimensions: 65mm x 100mm x 24mm (L x H x W)
Total weight: ~ 0,3 kg
You can use expert net control 2151 with PoE and Power supply unit as well.
6.4
Fabrique settings
In order to restore the default settings the device must be started in bootloader mode. Besides that the program GBL_Conf.
exe is required.
Run GBL_Conf.exe and select the device whose settings should be restored. Then click on Program Device -> Reset to Fab
default.
Please notice that all current settings will be deleted. The default settings will be loaded when the firmware of the device is
restarted the next time.