Warnings
A warning does not cause the pump to stop. A warning shows that
the system is approaching an alarm state.
All warnings are automatically acknowledged.
The individual sensors must be set before this menu can
be used.
System alarms
Set the required system alarms in this menu. See section about
system alarms.
Pump alarms
Set the required pump alarms in this menu. See section about
pump alarms.
Pump alarms contain alarms and warnings for the individual pump.
Mixer alarms
Set the required mixer alarms in this menu. See section about mixer
alarms.
Combi alarms
Combi alarms enable the user to combine two alarms in one. Both
alarms must be active before the SCADA system is called or an
SMS message is sent. See section about combi alarms.
Alarm status
If an alarm is enabled either as a warning or alarm, it is displayed in
one of the submenus.
Path:
Settings > Alarm settings
TM078728
Alarm settings
If the function "Pump groups" is enabled, the "Pump
alarms" submenu is split into two groups.
Path:
Settings > Alarm settings
Symbols show the status of each alarm input. Analog alarm inputs
can be displayed with both symbols. See the figure below.
TM078737
Example, Status, system alarms
Related information
8.5.1 System alarms
This display shows the parameters defined as system alarms.
Select the parameter to be monitored, and set it as desired.
System alarms can be triggered by two fault types:
•
Analog fault. See section about analog fault configuration. An
analog fault trips an alarm if its value lies outside a set limit.
•
Digital fault. See section about digital fault configuration. A
digital fault trips an alarm if a fault occurs (on/off).
Path:
Settings > Alarm settings > System alarms
TM078729
System alarms
Related information
8.4.2.1 Digital inputs and functions
8.5.5 Analog fault configuration
8.5.6 Digital fault configuration
60
English (GB)
