Gröne PowerSpray 64, Руководство пользователя

Страница: 58 / 342

58
damaged switch replace the switch
motor damage replace or repair the motor
Problem: the pump is not holding the substance and cannot be filled
Check: Solution:
low paint level refill
clogged inlet sifter clean
loosened suction tube tighten the connection
improperly placed inlet ball clean or replace
Problem: the engine cannot start the pump
Check: Solution:
paint hardened in the pump Replace the seals and clean all pump and filter parts
frozen paint in the pump defrost the pump
Problem: pressure problems
Check: Solution:
clogged tip or filter release the pressure excess and clean
Problem: the motor cannot hold the pressure
Check: Solution:
the tip is too big use device-specific tip
the tip is too big due to material consumption release the pressure excess and replace the tip
Problem: low power
Check: Solution:
used tip release the pressure excess and replace the tip
used seals replace the pump seals
clogged filter release the pressure excess and clean the filter
leaking drain valve release the pressure excess and repair the valve
suction tube is leaking or bent adjust the bend or tighten if needed
low voltage use shorter extension cord
pump is working when trigger is released Service the pump or tighten the sealant nut
Problem: the motor is not working continuously
Check: Solution:
pressure is too high when compared to tip size adjust proper pressure
Problem: the motor is hot and overloaded
Check: Solution:
the seals have been tightened too much adjust the sealing nut properly