Gröne PowerSpray 64, Руководство пользователя

Страница: 54 / 342

54
12. Hold the trigger in open position, let the pump work and observe the liquid coming out
of the gun. Let the liquid flow until all remaining parts of the spraying substance are gone
and there is only the clear rinsing liquid in the jet.
13. Not releasing the trigger, change the direction of the gun jet into the bucket for the rinsing
liquid and let it circulate for ca. 2 – 3 minutes which will help you make sure that the system has
been fully cleaned from the remaining parts of the spraying substance.
14. Switch off the device and remove the plug from the socket. Open the drain valve and release
the residual pressure.
15. Remove the suction tube from the rinsing liquid.
16. Clean the inlet sieve or the funnel sieve. Remove it, clean it with a soft brush while dipping
in a proper solvent and mount it back to its place.
17. If a given device comes with an additional pump filter, use a key to remove the filter nut. Re-
move the filter pump and clean it with a soft brush dipping it in a proper solvent. Mount it back
to its place and tighten.
18. Clean the gun, tip and gun filter, unfasten the hand protection and move it. Using a key (not
included in the set), untighten the nut on the bottom of the grip and remove the handle to re-
move the gun filter. Clean the tip and the filter with a soft brush dipping it in a proper solvent.
Pour in a small amount of a light oil (e.g. WD-40) inside of the gun casing. Place the filter
in the gun and reassemble the device. Tighten the nut with a key.
19. Clean the outside part of the sprayer with a damp cloth.
20. If you used water for rinsing, rinse it again with a special preserving liquid in order to avoid
corrosion of the inner part of the pump.
BE CAREFUL: never leave the pump for a longer period without a substance. After rinsing it with water
store the device for a couple of days. If the device is not used for a longer period, fill the pump system
with a special preserving liquid.
STORAGE
For long period storage fill the pump with a special preserving liquid.
To fill the pump:
1. Place the suction tube and the drain tube in a small amount of preserving liquid for storing.
2. Holding the drain valve open, switch on the device and turn the pressure regulation toggle
just start the pump.