X
Y
Table
Figure 111. Laser head assembly in lower left
corner of table.
Lower Beam
Raise Beam
Move Beam Left
Move Beam Right
Figure 110. Mirror thumbscrew adjustment.
Masking Tape
Mirror
Mirror
Alignment
Gauge
Mirror Assembly
Figure 112. Mirror alignment gauge installed.
Model G0911–G0914 (Mfd. Since 05/21)
-73-
18.
Check alignment by pressing Pulse button
on control panel. Compare results with those
shown in
Figure 108 on Page 72.
— If laser beam is in center of crosshairs,
alignment is optimal. Proceed to
Step 24.
— If laser beam is not in center of cross-
hairs, adjustment is required. Proceed to
Step 19.
19. Place mirror alignment gauge in front of pri-
mary Mirror #2 and hold in place with mask-
ing tape, as shown in
Figure 112.
20.
Verify Mirror #1 and Mirror #2 alignment by
pressing Pulse button on control panel.
— If laser beam is within center of mirror,
alignment is optimal. Remove mirror align-
ment gauge from Mirror #2, then proceed
to
Step 24.
— If laser beam is not in center of mirror,
adjustment is required. Proceed to
Step 21.
21. If no adjustments were made in Step 14,
loosen lock nuts on (3) brass thumbscrews
located behind Mirror #1 assembly (see
Figure 109 on Page 72).
22. Adjust direction of beam path by tightening
thumbscrews depending on desired direction
of beam travel, as shown in
Figure 110.
23.
Repeat
Step 20.
15. Adjust direction of beam path by tightening
thumbscrews depending on desired direction
of beam travel (see
Figure 110).
16.
Verify mirror adjustment by pressing Pulse
button on control panel. Compare results with
those shown in
Figure 108 on Page 72.
— If laser beam is in center of mirror, align-
ment is optimal. Proceed to
Step 17.
— If laser beam is not in center of mirror, adjust-
ment is required. Repeat
Steps 15–16.
17. Move laser head assembly to lower left cor-
ner of table (see
Figure 111).
Содержание G0911
Страница 100: ......
