Focus
Barrel
Focus
Gauge
Tab
Workpiece
72mm
Auto Focus
Sensor Mount
9mm
Figure 46. Focus gauge resting on workpiece
and auto focus sensor mount.
Figure 45. Auto focus sensor components.
x 1
-38-
Model G0911–G0914 (Mfd. Since 05/21)
Performing Track
Function
The "Track" function verifies the working envelope
of a selected file to prevent exceeding available
table area.
Note: This optional function is useful for setting
origin, and for reducing delays from travel errors
during cutting/engraving operations.
To perform "Track" function:
1.
Turn machine
ON and wait for startup proce-
dure to complete.
2. Load .RD file from machine memory (see
Loading .RD File From Machine Memory
on
Page 36).
3. Position workpiece so loaded file fits within
working envelope.
4.
M
ove laser head assembly to location of
origin defined in RDWorks, in reference to
working envelope.
Note: For example, if operator set origin to
center of image in RDWorks software, posi-
tion laser head assembly over center of table.
5. Press Origin button on control panel. Machine
will audibly beep to indicate origin has been
properly set.
6.
Loosen (1) cap screw on auto focus sensor
mount, raise auto focus sensor even with
tip of air nozzle, then tighten cap screw (see
Figure 45).
9.
Loosen (1) cap screw on auto focus sen-
sor mount, lower auto focus sensor flush
with workpiece, then tighten cap screw (see
Figure 45).
10.
Focal length is now correctly set.
Remove
focus gauge and setup tools before closing
top loading door.
7. Use arrow nav buttons to highlight "Z move"
(see
Figure 44 on Page 37).
8.
Place bottom of focus gauge on workpiece,
and raise or lower table using left and right
arrow nav buttons (
and
) on control
panel until tab on focus gauge rests on top of
auto focus sensor mount (see
Figure 46).
Auto
Focus
Sensor
Focus
Barrel
Auto Focus
Sensor Mount
Air Nozzle
Содержание G0911
Страница 100: ......
