Model G0715P (Mfg. 4/11+)
-67-
3. Loosen the two cap screws on the "L" bracket
(see
Figure 111), then slide it as needed to
move it into alignment with the blade.
Adjusting Bent Spreader/Riving
Knife
1. DISCONNECT SAW FROM POWER!
2. Bend the spreader or riving knife by hand
while installed, then follow
Steps 1–3 in
Checking Alignment to determine if it is par-
allel with the blade and inside the "Alignment
Zone" (refer to
Checking Alignment).
— If this does not work, remove it to straight-
en.
— If you cannot straighten it properly, replace
it.
5. Follow Checking Alignment, Steps 1–3.
— If the spreader/riving knife is in the align-
ment zone, no additional steps are neces-
sary.
— If the spreader/riving knife is still not in the
alignment zone, continue adjusting the
position of the "L" bracket as necessary to
correctly align the spreader/riving knife.
6. Tighten the two cap screws on the mount-
ing block to secure the spreader/riving knife
adjustment.
Cap
Screws
Figure 111. Cap screws for adjusting spreader/
riving knife position.
Cap
Screws
Fence Adjustments
There are four main adjustments for the fence:
height off the table, squareness, parallelism with
the miter slot, and clamping pressure. These
adjustments are interconnected and some repeti-
tion may be needed when adjusting.
Tools Needed
Qty
Hex Wrench 6mm .............................................. 1
Square ............................................................... 1
Felt-Tipped Marker ............................................ 1
"L"
Bracket
Figure 112. Location of screws used to adjust
fence parallelism and clamping pressure.
Front Lock Nuts
and Adjustment Screws
Rear Set Screws
4. Back out the rear set screws until they are
just threaded into the fence flange (see
Figure 112).
Height and Square
The fence should be adjusted high enough off the
table so that it does not drag across the surface or
allow wood chips to get caught between the fence
and table. Also, the fence face must be square to
the table in order to produce accurate cuts.
To check/adjust the fence height and square-
ness to the table:
1. DISCONNECT SAW FROM POWER!
2. Remove the fence from the saw and place it
on a flat surface.
3. Unscrew the front lock nuts and adjustment
screws shown in
Figure 112 until they are
barely threaded into the fence flange.
Содержание G0715P
Страница 18: ... 16 Model G0715P Mfg 4 11 Hardware Recognition Chart ...
Страница 88: ......