Grizzly G0715P, Руководство пользователя

Страница: 23 / 88

Model G0715P (Mfg. 4/11+)
-21-
Assembly
4. Thread each of the handles onto the
handwheels, then tighten them with a 14mm
wrench (see
Figure 14).
Figure 14. Handwheel installed.
Handle
5. Remove the six cap screws, flat washers,
and lock washers from both sides of the main
table.
6. Inspect the extension wings and main table
mating surfaces for burrs or foreign materials
that may inhibit assembly.
For a correct fit, the mating edges of the table
and wings must be clean, smooth, and flat. If
necessary, use a wire brush or file to remove
any flashing, dings, or high spots.
7. While a helper holds the wings in place,
attach each extension wing to the main table
with the three M10-1.5 x 25 cap screws,
10mm lock washers, and 10mm flat washers
removed in
Step 5 (see Figure 15).
x3
Figure 15. Extension wings installed.
Assembly consists of installing minor compo-
nents, the extension wings, fence rails, fence, and
blade guard.
To assemble the table saw:
Figure 13. Door installed.
Hinge
Socket
3. Before closing the door, thoroughly clean
the heavy-duty rust preventative off of the
gearing inside the saw and coat these with
the appropriate metal protectant (refer to
Lubrication on Page 58 for the location of
gears).
1. Remove the shipping brace (see Figure 12),
and reinstall the fasteners. Save the shipping
brace for later machine transport.
Figure 12. Shipping brace location.
2. Pull the magnetic switch out of the saw cabi-
net, and install the door by inserting the door
pins into the hinge sockets on the cabinet
(see
Figure 13).