-24-
Model G0715P (Mfg. 4/11+)
Figure 24. Magnetic switch installed.
23. Attach the magnetic switch to the bottom left-
hand side of the front rail using two M5-.8 x
12 cap screws, 5mm lock washers, and 5mm
flat washers, as shown in
Figure 24.
Power Connection
Before the machine can be connected to the
power source, an electrical circuit must be made
available that meets the minimum specifications
given in the "Circuit Requirements" on
Page 12.
If a power circuit has not been prepared for the
machine, do that now. To ensure a safe and code-
compliant setup, we strongly recommend that all
electrical work be done by a qualified electrician.
To connect to the power supply:
1. Make sure all previous assembly and setup
instructions in this manual have been com-
pleted.
2. Clear away all tools and objects used during
setup from the machine.
3. Insert the plug into a matching receptacle.
x2
18. Carefully slide the fence so it barely touches
the saw blade and lock it in place.
19. Lightly mark the "0" location on the fence
tube with a pencil, then remove the fence.
20. Peel the tape, carefully align the "0" mark on
the scale with the pencil mark you made on
the fence tube, and make sure the tape is
parallel to the fence tube along its length.
21. Re-install the fence, move it over to just touch
the blade, and verify that the indicator line is
directly over the "0" mark.
—If you need to correct the position of the
indicator line, loosen the screws on the
pointer window, adjust the pointer window
so the line is over the 0" mark on the tape
(see
Figure 23), then secure the screws.
Figure 23. Aligning rail tape with scale pointer.
Cap
Screws
Pointer
Window
Line
22. Install the blade guard as outlined on Page
32.
Содержание G0715P
Страница 18: ... 16 Model G0715P Mfg 4 11 Hardware Recognition Chart ...
Страница 88: ......