Model G0715P (Mfg. 4/11+)
-23-
12. Attach the rear rail to the holes on the main
table using two M10-1.5 x 25 cap screws,
10mm lock washers, and 10mm flat washers,
as shown in
Figure 20. Check to make sure
the rear rail is parallel to the table and below
the miter slots before completely tightening
the cap screws.
Figure 20. Rear rail installed.
x2
x2
16. Adjust the foot at the rear of the fence so that
the gap between the fence and the table top
is even from front to back.
17. Slide the fence up against the right hand edge
of the miter slot, and lock it in place. Examine
how the fence lines up with the miter slot.
Note: It is permissible for the back of the
fence to pivot outward not more than
1
⁄
64
" from
being parallel with the miter slot. This creates
a slightly larger opening between the fence
and the blade, at the rear of the blade, to
reduce the risk of workpiece binding or burn-
ing as it is fed through the cut. Many wood-
workers intentionally set up their fence in this
manner. Keep this in mind before adjusting
your fence. For more details, see
Figure 116
on
Page 69.
Figure 22. Checking fence parallelism with
blade.
Fence is
Parallel to
Miter Slot,
which is
Parallel to
Blade
Miter Slot
Blade
Fence
— If the fence is still parallel with the miter
slot, proceed to
Step 18.
— If the fence is not parallel with the miter
slot, then you MUST adjust the fence, as
described in
Fence Adjustments on Page
67, so that it is parallel.
—If the miter slot is not parallel with the blade,
you must follow the procedures described
in
Miter Slot to Blade Parallelism on
Page 63.
13. Secure the rear rail to the extension wings
with two M8-1.25 x 35 cap screws, four 8mm
flat washers, two 8mm lock washers, and two
M8-1.25 hex nuts.
14. Install the saw blade as outlined in Blade
Installation on Page 31.
Figure 21. Fence installed on rails.
Cam
Cam
Foot
15. Place the fence on the rails (on the right hand
side of the blade, as shown in
Figure 21).
Note:
Make sure the cam foot contacts the
cam on the fence lock handle before you
place the fence on the rail; otherwise, the
fence will not lock onto the rail tube.
Содержание G0715P
Страница 18: ... 16 Model G0715P Mfg 4 11 Hardware Recognition Chart ...
Страница 88: ......