Grizzly G0715P, Руководство пользователя

Страница: 35 / 88

Model G0715P (Mfg. 4/11+)
-33-
The blade guard, when properly installed,
should be setup similar to
Figure 40. It
should pivot freely up and down and return to
the table in the resting position. It should also
swing up high enough to accommodate the
workpiece.
Figure 41. Spreader/riving knife alignment zone.
Alignment
Zone
Spreader or
Riving Knife
Blade
Straightedge
7. Swing one side of the blade guard up and out
of the way.
8. While lifting up on the right spreader pawl,
place a straightedge against the blade and
the spreader, making sure the straightedge
does not touch a blade tooth.
When properly aligned, the spreader/riving
knife will be in the "Alignment Zone," shown
in
Figure 41, and will be parallel with the
blade.
— If the spreader/riving knife is not inside
the alignment zone and not parallel with
the blade, then it needs to be adjusted.
Proceed to "Adjusting Alignment
" on Page
66.
Figure 40. Blade guard installed.
6. Adjust the flat head screws to make sure
the table insert is flush with the table (use a
straightedge as a guide).
Anti-Kickback Pawls
The anti-kickback pawls allow the workpiece to
travel in only one direction. If the workpiece moves
backwards, such as during a kickback, the pawls
will dig into the workpiece to slow or stop it.
To work properly, the pawls must return to their
resting position after pivoting, as shown in
Figure
42, and they must not be engaged in the arresting
hooks.
Figure 42. Pawls in resting position.
Pawl
Arresting
Hooks
If the pawls fail to return to the resting position, the
pivot area may need to be cleaned or the spring
may have been dislodged or broken and will need
to be fixed/replaced.
Flat Head Screw