GreenTec RM 232, Руководство пользователя

Страница: 41 / 44

41
Rotary Mulcher RM 232
Storage
Never store the machine unprotected from humidity, wind and weather. Before storing the
machine, wash it thoroughly. Remove all traces of leaves/branches and dirt.
Be careful never to use a high pressure cleaner close to the paint work.
Only steam-clean with great caution. Avoid all detergents in order to avoid discoloration or
damage to the paint. It is important to keep the machine covered so that it is protected
from rain and sunlight. It must be placed horizontally on a level surface or pallet.
Make sure that when storing the machine there is no risk that it may tip
over or fall. Find a suitable disposal area or a place with sufficient support of the machine.
Afterwards, oil the machine with anti-corrosion oil, especially the parts that are polished
with use, such as blades, rotors and interior guardings. This minimizes rust formation and
extends the machine's durability significantly.
Anti-corrosive oils are hazardous for the skin and when inhaling. Be
aware of all safety precautions regarding use of the oil.
Do not leave hydraulic hoses on the floor. They can cause you to
stumble! Place all hoses above the machine/tool.
Always keep the machine and working tools in a clean condition! Dirt
attracts moisture and can thereby result in increased rust formation. Paint damages must
be repaired.
NOTE! MUST BE KEPT DRY! Risk of water in the bearings.
Keep in mind that the rotary mulcher is designed to withstand the most
difficult conditions and that with a little care and attention it will give you many years of
trouble-free operation. To avoid problems and ensure that the warranty covers, always use
original parts and make sure that the machine is not used for anything other than what is
described in this manual.
Scrapping
To ensure the most environmentally correct disposal method, the machine
must be separated and the disassembled parts sorted into the following categories:
Disposal of parts must be done in accordance with the applicable national legislation as
well as EU legislation.
Category Example of parts
Rubber and plastic
parts Hoses, rubber flap kit, support wheels, plast components,
etc.
Technical components Engines, hydraulic hoses, etc.
Pure metal
Panels, special section tubes, tubes, bearing cases, blades,
pulleys, etc.