GB - 28
To adjust cut height:
1. Using the grab handle (A), raise the
deck until the desired hole in the HOC
rod (C) is above the top of the frame (F)
and washer (E). See Figure 19.
2. To raise cut height by 1/4" (6 mm), insert
spacer (B) on HOC rod (C). See
Figure 20.
3. Insert hair pin (D) in the hole and set
deck back down. Insert hair pins from
the outside facing inward.
NOTE:
Ensure that washer (E) is positioned
between hair pin (D) and frame (F).
4. Repeat for three remaining HOC rods.
Figure 19
B
A
G
E
C
HOC Rod Position (Front Shown)
D
F
C
D
B
E
Figure 20
1
2
3
4
5
6
HOC Rod Position (Rear Shown)
HOC Rod Hair
Pin Position
Cut Height
Inch (mm)
Spacer
1
1.5 (38)
No
1.75 (44)
Yes
2
2.0 (51)
No
2.25 (57)
Yes
3
2.5 (64)
No
2.75 (70)
Yes
4
3.0 (76)
No
3.25 (83)
Yes
5
3.5 (90)
No
3.75 (95)
Yes
6
4.0 (102)
No
4.25 (108)
Yes
For HOC over 4.25 in. (108 mm):
ADDITIONAL CUTTING HEIGHT on
page 29.
F
