GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors 04/2011
13
Completing the wing
The only remaining task is to install the wing-mounted servos.
Use a fingertip to locate the slots in the servo well covers for the servo output arms,
and melt the film over them using the tip of a hot soldering iron. Press the rubber
grommets and metal spacer sleeves into the servo mounting lugs, then attach the
servos to the servo mounts using the retaining screws supplied with the servos; drill
1.5 mm Ø pilot-holes beforehand, working through the rubber grommets.
Connect the appropriate extension cables to the servo leads, and secure each
connection with a drop of glue or a heat-shrink sleeve to prevent them working loose.
Fit an M2 locknut and an M2 clevis on each threaded pushrod.
