GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors 04/2011
7
Remove the tailplane and fin, and run the tip of a hot soldering iron just inside the
marked lines on the tailplane to melt the film. Remove the superfluous film as shown.
The tailplane and fin can now be glued to the fuselage: position the tailplane as
described earlier, and tape it in place to prevent it shifting as the glue dries.
While the glue is hardening, press the rubber grommets and metal spacer sleeves
into the servo mounting lugs. Place the servos in the servo plate, and drill 1.5 mm Ø
pilot-holes for the servo retaining screws.
Mount the elevator, rudder and throttle servos in the servo plate as shown in the
photos below.
