GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors 04/2011
14
Cut down the servo output arms as shown in the photo, then fit them on the servo
output shafts and secure them with the output screws. Check that the outermost hole
in each arm matches the diameter of the clevis pin.
Ensure that the servos are at centre before fitting the output arms on the output
shafts.
You will find lengths of thread in each wing panel; use the threads to draw the servo
leads through the wing panels to the centre section.
Fix the servo well covers to the wings using the retaining screws supplied.
Connect the pushrod to the servo output arm as shown in the photo. Set the servo
and control surface to centre, then set the pushrod to the correct length before
connecting the clevis to the control surface horn.
