GRAUPNER mz-32 HoTT, Руководство пользователя

Страница: 27 / 48

27 / 48 S1024.mz32_V1.7_sh_en
A Ʃ en ƟŽŶ
If you tap on the bind group bind number ID in the “RF Set” menu
the transmi
Ʃ er will release the bind from the ĂĐƟ ve model memory
provided that RF is switched o ī .
Binding procedure step-by-step
1. Move transmi Ʃ er and receiver at a moderate distance from each
ŽƚŚĞƌ;ϯϬĐŵŽƌϭŌͿ͘
2. Switch on the mz-32 HoTT transmi Ʃ er without switching on the
RF or set the RF Transmission to "OFF" in the "RF Set" ĮĞůĚ of the
"RF Set" menu.
3. Switch the receiver power system on.
4. Put the receiver in bind mode according to its manual.
5. In the transmi
Ʃ er display ͕ touch the desired value ĮĞůĚ "RX1 ...
RX4" in the "Bind" column to enable the transmi Ʃ er-side binding
process.
If the bind was successful you will ŶŽƟĐĞ in the Rx column of the
transmi Ʃ er the number of receiver channels for example R6, R12
with a highlighted blue background and the LED on the receiver will
change its color or state.
In case of an unsuccessful bind change the
ƉŽƐŝƟŽŶƐ of the devices
and repeat the en Ɵ re procedure.
Delete exis ƟŶŐďŝŶĚŝŶŐ step-by-step
1. Switch on the mz-32 HoTT transmi Ʃ er without switching on the
RF or set the RF Transmission to “OFF” in the “RF Set” ĮĞůĚ of the
“RF Set” menu.
2. In the transmi Ʃ er display ͕ touch the desired value ĮĞůĚ "RX1 ...
RX4" in the "Bind" column to trigger a transmi Ʃ er-side binding
process. The exis ƟŶŐ binding is deleted in the course of the bind-
ing a Ʃ empt (receiver has to be switched Žī for removing the
ďŝŶĚͿ
Range test
When the range test starts, the output of the transmi Ʃ er decreases
ƐŝŐŶŝĮ cantly. A pr ĂĐƟ cal ĨƵŶĐƟŽŶĂů test can therefore be performed
at a distance of less than 100 m. A Ō er the the end of the range test,
the transmi Ʃ er switches back to full output power and the range
test signal tone stops.
If necessary ask someone for help.
Range test step-by-step
1. Verify that the receiver and transmi Ʃ er are communic ĂƟŶŐ prop-
erly and that all control surfac ĞƐĂƌĞĨƵŶĐƟŽŶĂů͘
2. Place the model on a ŇĂƚ surface (cemen ƚ͕ mowed lawn or ŐƌŽƵŶĚͿ
with the receiver antenna at least 15 cm above ground.