GRAUPNER MX-16S, Руководство по программированию

Страница: 75 / 116

75
ons, fl uctuations in system rotational speed and other in-
fl uences.
However, in an autorotation descent the main rotor is not
driven by the motor, and therefore there is no torque ef-
fect for which compensation is required, i.e. which the
tail rotor would have to correct. For this reason all the
appropriate mixers are automatically switched off in au-
torotation mode.
However, the basic tail rotor setting has to be different
for autorotation, as the compensatory thrust described
above is no longer required.
Stop the motor and place the helicopter horizontal. With
the transmitter and receiving system switched on, select
the »
Autorotation « fl ight phase. Fold both tail rotor bla-
des down and change the blade pitch angle to zero de-
grees using the “Tail rotor” menu. Viewed from the rear,
the tail rotor blades should now be parallel to each other.
Depending on the friction and running resistance of the
gearbox, you may fi nd that the fuselage still yaws slight-
ly in an autorotation descent. If necessary, the relatively
slight torque which causes this effect must then be cor-
rected by adjusting the tail rotor blade pitch angle. This
value will always be a small fi gure between zero de-
grees and a pitch angle opposed to the direction of tail
rotor pitch required for normal fl ight.
Heli mixer / Autorotation – Model helicopter