GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors Id. No. 0061845 04/2010
5
through the holes in the ribs at the trailing edge; leave it projecting by about 10 mm,
and glue it in place with cyano. Glue the gussets (23) to the rib (11) and the leading
and trailing edges, the gussets (24) to the rib (10) and the pivot tube (14), and the
gussets (25) to the ribs (5-z + 10-z) and the pivot tube (14) using cyano.
Glue the spar webs (16 + 17) to the spars on the side facing the leading edge.
When the adhesive has set hard, glue the dowel support (18) to the sheeting (13)
and the spar web (16), with the hole adjacent to the rib (4). Let the glue dry, then drill
a 4.0 mm Ø hole in the leading edge to accommodate the locating dowel (note: the
dowel must lie parallel with the rib (4)).
Offer up the leading edge sheet panel (19), and check that its width is correct; trim if
necessary. Apply glue to the contact surfaces of the wing structure. Fit the sheeting
in the recess in the leading edge, and pin it in place using a spare strip of wood to
spread the load, then roll the sheeting back over the ribs and onto the spar. Clamp
the sheet panel to the spar using a packing strip to avoid damaging the surface.
