GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors Id. No. 0061845 04/2010
6
Cut the in-fill piece (20) to length, trim it to fit between the wing joiner tube (15) and
the spar (3), then glue it and the webbing (16 and 17) in place using plenty of UHU
plus (epoxy). Clamp the webbing in place while the glue is hardening.
Cut out the hole for the servo lead in the bottom wing sheeting as shown on the plan.
Trim the upper root sheeting (21) to fit, and glue it in place flush with the outside of
the rib (5). When the glue has set hard, sand back the excess leading and trailing
edge strips and the sheeting until these parts are flush with the rib (4).
Glue the root facing rib (4.1) to the bevelled face of the triangular strip (26).
