GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors Id. No. 0061845 04/2010
13
Insert the fin in the slot in the top of the fuselage, align it carefully, and mark the out-
line of the fuselage on the bottom of the fin. Remove the fin and melt the film by run-
ning a hot soldering iron just inside the marked lines. Peel off the unwanted film, then
glue the fin in the slot, taking care to keep it exactly vertical relative to the wing.
Installing the servos in the fuselage
Remove the peel ply (tear-off fabric) from the fuselage to leave a rough surface be-
fore gluing the servo plate (89) in the fuselage (trim to length and width if necessary).
Cut the snake outer sleeves to the lengths shown in the picture.
Fit the servos in the openings, drill the pilot-holes, and screw them in place.
