8
The depth of the servo openings is mechanically prefabricated; it may, however, be
necessary to adjust the depth of the openings by removing further Styrofoam (as
much as possible, until veneer with a fibre orientation transverse to the wingspan
becomes visible).
While waiting for the the adhesive to cure, prepare the servo control horns as shown
in the photo. The outer hole may need to be drilled open to a diameter of 1,6 mm to
accomodate the push-rod.
With servo in the centre (neutral) position the prepared servo levers are mounted on
each respective servo and tightly screwed down. In order to do this, place the servo
via the remote control in neutral position.
