4
Applicable law
German material law applies exclusively to this declaration and the claims, rights and
duties arising from it, excluding the provisions of international private law and UN
Sales Law.
The following points must always be observed:
•
Check before launching the model that the remote control system is functioning
correctly and that all mechanical and ellectrical connections are secure.
•
The batteries are fully charged and the range of the remote control system is
checked. In particular the transmitter and and receiver batteries must be charged.
•
Check that the radio control channel in use is free. Never fly your model if you are
unsure whether the channel is free.
•
Follow the recommendations and instructions supplied with your remote control
system and accessories.
•
Ensure that all control servos are operating freely and not mechanically restricted.
•
Batteries must not be short-circuited.
•
Remove the batteries for transport and whenever the model is not in use.
•
Do not expose your model to extreme temperatures, high levels of humidity or
dirt.
•
Secure the model and RC-components during transport against damage or
slipping.
•
IMPORTANT:
The model’s built-in battery must not be disposed of with
household waste. The battery must be disposed of in battery recycling containers.
•
IMPORTANT:
The model and the transmitter must not be disposed of with
household waste, but must be taken to a recycling depot for disposal as electronic
scrap. Contact your local council for further information.
Pre-Flight Checks
Before each flight check the correct function and range of the radio control system by
switching on the transmitter as well as the receiver, extend the transmitter antenn
and check from an appropriate distance that all control surfaces are operating
correctly, both in terms of magnitude and sense.
Depending on your level of experience and particularly in the case of the first flighgts,
it is advantageous to have an experienced helper by your side to offer assistance
with the pre-flight checks and first flights.
Care and Maintenance
•
Clean the model after each flight. Only use suitable cleaning products for cleaning
the model and the RC-components. Contact your specialist dealer for information
about this.
•
When cleaning decor print products (decor sheets, design foils) detergents which
contain solvents must not be used as they can damage or destroy prints. Please
use warm soapy water and a soft cloth for cleaning.
