7
Recommended servos for:
Rudder and
DES 678 BB,MG
order no. 7943
Elevator
Ailerons and
DES 448 BB,MG
order no. 7914
Wing flaps
Receiver power supply
PRX-3A
order no. 4135
As receiver a DS 19 or SMC 19 or SMC 14 can be used
Required servo extension cables
Order no. 3935.18 for connection to receiver (4 pieces)
For the receiver battery we recommend: Order no.
7674.2
which must always be
properly maintained and charged before and after each flight, i.e. the battery ought to
be be discharged and re-charged several times until it reaches the full specified
capacity.
Re-chargeable batteries are recommended for the receiver and transmitter as they
provide the highest level of safety. For suitable battery chargers see our catalogue.
Assembling the ALPINA 3001 CHAMP PRO
Only begin the assembly after you have familiarised yourself with the individual
components and construction stages. In the event that a component should give
reason for complaint this should be communicated to your specialist dealer prior to
the start of construction.
The wings
Feel with your fingertips for the servo openings for the aileron and flaps servos, then
melt them free with a hot soldering iron or cut free with a sharp balsa knife and adjust
to accomodate the control horns as nesssary. As shown in both photos glue in the
GRP control horns using suitably thickened epoxy resin.
