GRAPHTEC FC5100-100, Руководство пользователя

Страница: 62 / 201

Preparing to Cut: Changing Feed Speed
61
Checking the
Cutter Path
Use the light pointer to verify the contour cut before actually cutting the job.
Select the light pointer as the tool and reduce the pen speed as low as possible so
that its path is visible on the media.
Send the cut data to the plotter. The plotter runs the job with the light pointer
turning on and off to represent the PEN UP/DOWN status. The light pointer is off
to show when the pen is UP. The light pointer is on to show when the pen is
DOWN.
Changing Feed Speed
This function allows you to change the media feed speed from SLOW to NOR-
MAL. In the case of selecting ROLL-1 and SHEET on the media type menu, the
plotter uses SLOW to ensure the accuracy of the leading and trailing edges of the
media. After the initialization, the feed speed can increase once the grit rollers
and the pinch rollers secure the media. Always select SLOW for heavy media or
media with a slippery surface, otherwise select NORMAL to shorten the initializa-
tion time. Remember that the media will back up at the pen up speed when NOR-
MAL is selected.
For details see FEED – Advancing Media.
When the media set lever is lowered, the following menu appears on the display:
• Press the F4 key.
• Press the F3 key to select INITIAL FEED SPEED.
• Press the F3 key to select NORMAL or the F4 key to select SLOW.
• Press the ENTER key to return to the previous menu.
• Press the NEXT key to advance to the next menu.
LOAD MEDIA!
INITIAL MENU> .
AUTO PRE FEED> .
INITIAL FEED SPEED> .
INTERFACE> .
INITIAL FEED SPEED
.......... NORMAL .
SLOW .