Out of the Box: Installing the Accuload System
22
Installing the Accuload System
The Accuload
™
system consists of two media brackets, two stock rollers and
one media alignment bar.
Installation procedure:
1
Place the right media bracket against the inside surface of the plotter’s side
box (right).
2
Insert an M4 screw in the second hole from the front side of the plotter.
NOTE:
Do not over tighten. The bracket should rotate easily.
NOTE:
When attaching the bracket onto the cutter, use the foam shipping cover to pro-
tect the cutter.
CAUTION:
Do not lay the cutter on it’s back side, this may damage the Media Set Lever.
3
Insert an M4 screw in the third hole from the front side of the plotter.
4
Secure the first screw.
5
Secure the second screw.
6
Repeat steps 1-5 with the left Media Bracket.
7
Place the media alignment bar in between the tabs of the media brackets that
protrude from the front side of the plotter.
Front
Media Bracket Right
Media Bracket Left
M4 Screw
Содержание FC5100-100
