Grandstream Networks, Inc.
DP715-US/DP710-US User Manual
Page
31 of 43
Firmware 0.0.0.8
Last Updated: 03/2012
Table 9: Advanced Settings
Admin Password
This contains the password to access the Advanced Web Configuration page. This field is
case sensitive. Only the administrator can configure the “Advanced Settings” page.
Password field is purposely left blank for security reasons after clicking update and saved.
The maximum password length is 25 characters.
Layer 3 QoS
This field defines the layer 3 QoS parameter which can be the value used for IP
Precedence or Diff-Serv or MPLS. Default value is
48
.
Layer 2 QoS
Value used for layer 2 VLAN tag. Default setting is
blank
.
STUN Server
IP address or Domain name of the STUN server.
Keep-alive interval
This parameter specifies how often the DP715 sends a blank UDP packet to the SIP
server in order to keep the “hole” on the NAT open. Default is 20 seconds. Minimum
value is 20 seconds.
Use STUN to detect
network connectivity
Use STUN keep-alive to detect WAN side network problems. If keep-alive request does
not yield any response for configured number of times, the device will restart the TCP/IP
stack. If the STUN server does not respond when the device boots up, the feature is
disabled. Default setting is
No.
Firmware Upgrade
and Provisioning
Enables DP715 to download firmware or configuration file through either the TFTP, HTTP
or HTTPS server.
Via TFTP Server
This is the IP address of the configured TFTP server. If selected and it is non-zero or not
blank, the DP715 retrieves the new configuration file or new code image from the
specified TFTP server at boot time. After 5 attempts, the system will timeout and will start
the boot process using the existing code image in the Flash memory. If a TFTP server is
configured and a new code image is retrieved, the new downloaded image is saved into
the Flash memory.
Note: Please do NOT interrupt the TFTP upgrade process (especially the power supply)
as this will damage the device. Depending on the local network, this process can take up
to 15 or 20 minutes.
Via HTTP / HTTPS
Server
The URL for the HTTP/HTTPS server used for firmware upgrade and configuration via
HTTP.
For example
, http://provisioning.mycompany.com:6688/Grandstream/1.0.0.67“
:6688
” is
the specific TCP port where the HTTP or HTTPS server is listening; it can be omitted if
using default port 80.
Note: If Auto Upgrade is set to No, DP715 will only do HTTP/HTTPS download once at
boot up.
Firmware Server Path
IP address or domain name of firmware server.
Config Server Path
IP address or domain name of configuration server.
XML Config File
Password
The password used for encrypting the XML configuration file using OpenSSL.
This is required for the phone to decrypt the encrypted XML configuration file.
HTTP/HTTPS User
Name
The user name needed to authenticate with the HTTP/HTTPS server.
HTTP/HTTPS
Password
The password needed to authenticate with the HTTP/HTTPS server.
Firmware File Prefix
Default is
blank
. If configured, DP715 will request firmware file with the prefix. This
setting is useful for ITSPs. End user should keep it blank.
