Flushing
3A1602H
25
Flushing
•
Generally, flush if you will be shut down for more
than 3 days. Flush more often if material is moisture
sensitive and humidity is high in the storage area, or
if material may separate or settle out over time.
•
Flush out old fluid with new fluid, or flush out old
fluid with a compatible solvent before introducing
new fluid.
•
Use the lowest possible pressure when flushing.
•
Always leave some type of fluid in system. Do not
use water.
•
For long term storage, flush out the solvent with a
storage fluid such as Bayer Mesamoll plasticizer or,
at minimum, clean motor oil.
1.
Engage piston safety lock or trigger safety lock.
Close fluid valves A and B. Leave air on.
2.
Set function knob to Stop/Park.
3.
Remove both recirculation tubes from material pails
and secure each one to a dedicated waste con-
tainer.
4.
Turn Recirc/Spray valves to Recirc.
5.
Set function knob to Fast Recirc
. Pump mate-
rial from fluid inlet tubes until no more comes out.
6.
Set function knob to Stop/Park
.
7.
Set function knob to Fast Recirc
. Pump solvent
through system into waste containers.
8.
When nearly clear solvent exits the fluid inlet tubes,
set function knob to Stop/Park
.
NOTE:
To flush the spray gun, refer to your separate
spray gun instruction manual.
Flush equipment only in a well-ventilated area. Do
not spray flammable fluids.
F
IG
. 40
F
IG
. 41
+
-
TI17127b
F
IG
. 42
F
IG
. 43
F
IG
. 44
TI17126a
TI17133a
+
-
TI17130b
Содержание Reactor E-8p 3A1602H
Страница 16: ...Setup 16 3A1602H 12 Install fluid tubes 36...
Страница 36: ...Repair 36 3A1602H FIG 56 Function Knob Potentiometer ti17465a 10 61 12 16a 23 22 87 16 N S P...
Страница 40: ...Repair 40 3A1602H FIG 59 Pressure Transducer Connection 35 ti17467a 33...
Страница 56: ...Dimensions 56 3A1602H Dimensions 34 58 in 87 8 cm 24 12 in 61 3 cm 15 06 in 38 3 cm TI17120a...