Graco Baby Delight, Инструкция по эксплуатации

Страница: 6 / 45

11 10
Storage
On/Off
See images -
See images -
See images -
See images -
30
28
25
32
Toy bar
31
29
26
33
Front Tube
Attaching Seat to Frame
See images -
Use slide adjuster at shoulder and waist for
further adjustment. Repeat on other side.
When changing harness strap slots,
MAKE SURE harness straps are going through
same slots in seat pad and seat back.
The harness straps must go into the slot that
is even with or slightly above the shoulders.
Avoid twisting straps.
22
Attaching Legs
See image
8
To Secure Child
17
Installing Batteries
Swing the legs outward until the single button
snaps into its notch. CHECK that the legs are
properly attached by twisting them in the housings.
Press in both recline latches on back of seat to lower.
To raise, push seaat back up to desired position.
9
21
24
23
With baby out of swing, open the battery
compartment lid by inserting a key into the
slot. Insert four “C”-LR14 (1.5V) cell batteries.
Replace battery lid.
CHECK that the batteries are put in correctly.
Your swing will not run if the batteries are put
in backwards. Refer to the warnings section for
safe battery use.
Check to make sure toy bar is secure by pulling on it.
CHECK that legs are properly attached by twisting
them in the housing.
See image
Snap swing seat into brackets as shown. Pull down
on swing arms to make sure it is securely snapped
into handles.
Make sure straps on mesh sides are not twisted.
Snap seat back into smaller hole on mesh sides.
27
33
12
13
14
1
Starting Product
WARNING: avoid serious injury from falling or sliding
out. Always use harness. After fastening buckles, adjust
belts to get a snug fit around your child.
Observe the swinging motion for a minute. It takes
time for the product to adjust to a setting. Change
setting if needed.
A small, quiet baby will swing higher on each setting
than a larger, more active baby.
Your seat may be stopped at any time the motor is
running without damaging the motor. Push product to
restart.
If your product motor stops operating by itself, a
protective device may have been activated. Turn off
motor, wait three minutes, then restart swing.
GB
Rear Tube
To Adjust Recline
See image
CHECK that legs are properly attached by twisting
them in the housing.
See image
Check to make sure seat bottom and seat back are
securely snapped into mesh sides by pulling on the
base of mesh sides.
Insert plastic tab into bottom slot on the side of
the seat back. Attach tab to hook on back of seat.
Repeat on the other side.
See image
See image
See image
Attach elastic loop on mesh sides, to plastic hook
on bottom of handle. Repeat on other side of
swing.
Snap seat bottom into large hole on mesh sides.
10
11
16
3
7
4
5
6
15
2
Instructions
Assembling Product