Operation
332462A
9
Operation
BEFORE OPERATING THE G-FLEX 1500, AN AUTO
SCAN MUST BE PERFORMED TO FIND THE
RESONATE FREQUENCY OF THE TABLE AND THE
HOPPER.
Refer to Startup Procedure, page 8.
Part Table Feed Rate
1.
Place 4 to 20 parts on the table.
2.
Turn the table on either through the M12 input or
manually, see
Manual Operation in Override
Mode
, page 12.
3.
For course adjustment,
PRESS AND HOLD
the UP
or DOWN arrow key until the parts are moving close
to the desired feed rate. This directly changes the
Amplitude value.
4.
For fine tune adjustment REPEATEDLY PRESS the
UP or DOWN arrow keys to dial in on the desired
feed rate. This directly changes the CFR Value.
5.
Once the feed rate is determined, record the CFR
value of the part for future reference on the CFR
Value table provided on page 31.
6.
When the feed rate is set, turn table OFF.
Hopper Feed Rate
1.
Ensure hopper door is set at its lowest position.
2.
Insert parts into the hopper.
3.
Set hopper door to desired location to control how
parts transfer from hopper to feed tray.
NOTE:
If the hopper adjustable gate is set too low,
parts can get jammed and not properly feed.
4.
Turn the hopper on either through the M12 input or
manually, see
Manual Operation in Override
Mode
, page 12.
5.
For course adjustment,
PRESS AND HOLD
the UP
or DOWN arrow keys until the parts are moving
ti21444a
ti21920a
ti21919a
ti21478a
ti21659a
