Lifting Instructions
332462A
5
Lifting Instructions
1.
Always use BOTH designated mounted lifting lugs
when lifting the G-Flex 1500. See
Component
Identification
, page 4, for location of lifting lugs.
Installation
When choosing a location for the G-Flex 1500, make
sure the mounting plate is a minimum of 4 in. away from
any other piece of equipment. Refer to the anchor bolt
manufacturer for a minimum edge distance to the con-
crete slab. Follow local regulations in regards to spacing
for control panel access.
Floor Preparation
1.
The G-Flex 1500 must be mounted on a level con-
crete surface.
2.
To mount the G-Flex 1500 postition it in the desired
location. The G-Flex 1500 Floor Mounting Plate (J)
is designed to be anchored using four 3/8 in. con-
crete anchor bolts.
3.
Use a concrete drill bit of the size recommended by
the anchor bolt manufacturer. Drill 4 holes in the
concrete using the Floor Mounting Plate holes as a
guide. Install the anchor bolts per the manufac-
turer’s instructions.
4.
A minimum of 1 in. of stud length must protrude
from the floor for proper installation.
5.
Install four washers (64) and four nuts (65) provided
to secure the G-Flex 1500 to the concrete surface.
6.
Torque to anchor bolt manufacturer recommenda-
tion.
To prevent crush injury or equipment damage when lift-
ing the G-Flex
™
1500, only use approved (e.g., ANSI)
slings and equipment rated for the weight of the
G-Flex
™
1500 (see
Technical Specifications
, page
30).
ti21756a
ti21685a
ti21660a
ti21683a
ti21685a
64
65
