-7-
30mm Conector Bolt
1/4" Square Nut
35mm Connector Bolt
1/4" Cap Nut
Leg Brace
30mm Conector Bolt
1/4" Square Nut
35mm Connector Bolt
1/4" Cap Nut
Leg Brace
30mm Connector Bolt
1/4" Cap Nut
Leg
Fig. 4-1
Fig. 3-2
Fig. 3-1
Step 3: Leg to Frame Assembly
Parts Needed:
2- Frame End Assembly
4- Legs
8- ¼” x 30mm Connector Bolt
8- ¼” Cap Nut
Step 4: Leg Brace Assembly
Parts Needed:
4- Braces
4- ¼” x 30mm Connector Bolt
4- ¼” Cap Nut
4- ¼” x 35mm Connector Bolt
4- ¼” Square Nut
4-1:
Put a square nut into the “T”
slots in each of the Leg Braces.
4-2:
Put a 35mm connector bolt
through the hole on each Leg.
4-3:
Now screw the bolt into the nut
that you installed in the Leg Brace.
4-4:
Insert a 30mm connector bolt
through the brace and into the Table
Track Support.
4-5:
Insert a Cap Nut through the hole
in the Table Track Support, then thread
onto the end of the bolt.
4-6:
Follow the above steps for the
remaining three Leg braces.
3-1:
Attach the Legs to the Frame End
Assembly using (2) 30mm Connector
Bolts, and (2) 1/4” Cap Nuts per leg, make
sure the Legs angle outward as shown.
3-2:
Create another Leg to Frame
Assembly by repeating this step.
