-6-
1/4" X 35mm
Connector Bolt
Table Brace
Rail Tarck Support
1/4" X 35mm
Connector Bolt
Frame End
1/4" X 35mm
Connector Bolt
Table Brace
Rail Tarck Support
1/4" X 35mm
Connector Bolt
Frame End
1/4" X 35mm
Connector Bolt
Table Brace
Rail Tarck Support
1/4" X 35mm
Connector Bolt
Frame End
1/4" X 35mm
Connector Bolt
Table Track Support
Table Brace
1/4" Square Nut
Fig. 1-1
Fig. 1-2
Step 1: Table Brace Assembly
Parts Needed:
4- Table Brace
4- Table Track Supports
8- ¼” x 35mm Connector Bolt
8- ¼ #20 Square Nut
Step 2: Frame End Assembly
Parts Needed:
2- Frame Ends
2- Table Brace Assembly
4- ¼” x 35mm Connector Bolt
4- ¼” Square Nut
**Square Nuts may need to
be pushed in with a screw
driver or tapped in with a
hammer.**
1-1:
Attach two Table Braces to
two of the Table Track Supports.
Place the Table braces on your
working surface with the “T” slots
facing up. Also place the Table
Track Supports on your working surface with the two
holes closest to the end to your left, and the edge with
the slot running it’s entire length facing down.
1-2:
Insert a square nut into all of the “T” slots in
each of the Table Braces. Then insert a 35mm connector bolt through
each of the appropriate holes in the Table Track Supports. Now thread the bolt into the square nuts
already in the “T” slots of the Table Braces. Tighten the bolts with a 4mm Allen wrench (Supplied in
hardware kit).
1-3:
Repeat steps 1-1 and 1-2 to build another
Table Brace Assembly.
2-1:
Flip the Table Brace Assembly
so the slotted edges face up.
2-2:
Place a square nut into the
“T” slots at the ends of each Table Track
Support.
2-3:
Insert 35mm bolts through the Frame End, and thread into
the square nuts (previously installed), as show Fig. 2-2.
2-4:
Repeat steps 2-1 to 2-3 to build another Frame End Assembly.
Fig. 2-2
Fig. 2-1
