-21-
1/4" Washer
3/16" Washer
1/4" Nylock Nut
Pedal Clamp Spacer
Back Lever Linkage
Front Lever Linkage
60mm Connector Bolt
50mm Connector Bolt
45mm Connector Bolt
1/4" X 3" Carriage Bolt
Pedal Clamp Spacers
3/16" Washer
1/4" Jam Nut
1/4" X 3" Carriage Bolt
Pedal Clamp Spacers
3/16" Washer
1/4" Jam Nut
Fig. 16-2
16-3
•
a -
Insert a 60mm Connector Bolt through
the hole towards the top of the Back Lever. •
b -
Slide a Pedal Clamp Spacer (cupped side first) onto
the end of the bolt. •
c -
Next apply a ¼” washer.
•
d -
Put the Back Lever Linkage onto the end of the
60mm connector bolt. •
e -
Place a 3/16” washer and
then a nylock nut onto the end of the bolt.
16-4
•
a -
Insert a 50mm connector bolt through the available
hole in the Back Lever Linkage. Next slide a ¼” washer onto
the end of the bolt. •
b -
Now put the bolt through the
available hole closest to the middle of the middle Lever.
•
c -
Place a 3/16” washer and then a nylock nut on the end of the 50mm
connector bolt.
Step 17: Spacer Assembly
Parts Needed:
2- Pedal Clamp Spacers
1- ¼” x 3” Carriage Bolt
1-3/16” Washer
1- ¼” Jam Nut
17-1
•
a -
Insert a 3” Carriage Bolt through the last
available hole in the Middle Lever. The head of the bolt
needs to be on the outside of the carriage. (Fig. 17-1).
•
b -
Slide one Pedal Clamp Spacer onto the end of
the bolt, with the cupped side facing out.
•
c -
Slide a 3/16” Washer onto the bolt.
•
d -
Completely tighten a 1/4” Jam Nut onto
the end of the bolt. (The square base of the
bolt should pull all the way into the wood.)
•
e -
Slide the other Pedal Clamp Spacer
onto the end of the bolt. (Cupped side
can face ether way.)
Fig. 17-1
Fig. 17-2
