2.6.
RJ-45 Ethernet Port
The Logic-5000 radio modem can accept either a standard or cross over ethernet cable.
2.7.
Power Cable Connections
If using the provided power cable to connect to a DC supply (car battery) use the following
diagrams and table to connect the unit.
Ensure the ignition sense line is connected to the vehicle's ignition. This line will initiate the
shutdown timer following ignition deactivation (if enabled).
Note: Both ignition sense and DC power are required to start up a Logic-5000.
Caution:
Connect the red power wire to a
CONSTANT
hot source. To prevent corruption of
the Logic-5000 firmware, only use the ignition source to power off the unit.
Figure 3
- Logic-5000 power cable connections
Pin
Color
Description
1
Red
DC Power, 9 to 28V DC
2
Blue Ground
3
White Ignition
Sense
4
NA Not
Connected
2.8.
Antenna Options
Antennas are available for Logic-5000 radio modems installations from GPS Logic.
Page 9 of 59
