5.7.3.3.
Delete Custom IP Filters
Figure 27 –
Advanced Settings -> IP Filters, Custom IP Filters table
Click the
Del
link to delete the corresponding filter entry.
5.7.4.
Advanced Settings – IPsec
5.7.4.1.
IPsec Support
Selecting Enable will launch the IPSEC process and start all the enabled set tunnels.
Selecting Disable will stop all tunnels and shutdown the main process. By after, all the
enabled tunnels will be launched automatically when the unit connects to the cellular
carrier.
5.7.4.2.
IPsec Configuration
Figure 28
– Advanced Settings -> IPsec, IPsec Configuration section
Tunnel no:
Tunnel number, start at 1 and increment for each new tunnel. If you want to
modify an existing tunnel, use its number from the table below. The Enabled checkbox will
enable autostart directly after you saved the tunnel.
Label:
This is a convenience label used to differentiate tunnels easily.
Remote IP Address:
The Logic-5000 is considered the left local side, the remote IP is the
address of the right remote side where the unit will connect to establish a tunnel.
Remote Subnet:
If you tick the
Enabled
checkbox, enter the IP netmask protected on the
remote side, for instance 10.0.0.0/24. If checkbox is not ticked, no subnet will be used and
encryption is possible when the destination IP is the VPN gateway itself (Remote IP address
above), it is useful if you use port forwarding from your VPN gateway to servers.
Page 44 of 59
