2
MDE-LEDI-NETWORK-TDS-4099V3.0
WARNING! The following section provides the safety instructions for installation.
Please read it carefully before installing your device.
To protect your device, plug it into a grounded outlet.
The device must be connected to an electrical installation which is in accordance with
the NF C15-100 standard.
The wiring installation must include an easily accessible breaking device (circuit
breaker or disconnecting switch). This device must withstand the nominal voltage and
current values indicated on the device.
In Europe: in accordance with European regulations on the protection of individuals
and the environment, it is your responsibility to dispose of this equipment at a collection
site designed for this purpose (separately from household waste). For further
information, contact your reseller, your collection site or the relevant local authorities.
Any modification or opening of the product without the consent from the Customer
service department will void the warranty.
The
LEDI® NETWORK TDS
must only be installed, maintained and handled by
competent and knowledgeable persons.
All maintenance operations must be carried out with the power off, including for
systems connected to any relay outputs.
As a general rule, to avoid any interferences, the power (230V supply) and signal (time
information) cables must not be too close to each other. (keep a few centimetres apart)
CAUTION! After unplugging the
LEDI
®
NETWORK TDS
, there is a risk of electric shock
from the power connector/plug socket for up to 2 seconds.
To avoid the risk of electrical interference, position the
LEDI
®
NETWORK TDS
as far
as possible from sources of radiation (Loudspeakers, antennas, high-frequency
equipment, electromagnetic alarms
…).
Gorgy Timing disclaims all liability in the event of accident or damage caused by
improper use of
LEDI
®
NETWORK TDS.
All GORGY TIMING products comply with the following standards: CE, EN60950-1,
EN55022 class B, EN50024.
IMPORTANT SAFETY INSTRUCTIONS
