Gorenje Aqua ECOLOGIC, Инструкция по использованию, техническому обслуживанию и монтажу, Страница: 7 / 112

AQUA ECOLOGIC | instructions for use, maintenance and installation | September 2015
7

the type of stove to be connected,

whether the room corresponds to the stove where the stove will be installed, which is expressed
as the minimum size required for installation, set forth by the manufacturer of the stove,

heat generator

manufacturer's instructions regarding the requirements of smoke removal systems (ducts and
pipes for smoke exhaust),

inner cross section of the chimney, the material out of which the chimney is made, uniform
cross section,

that there are no disturbances and obstacles in the chimney,

height and vertical extension of the chimney,

altitude at the place of connecting the stove,

the existence and suitability of the protective cover for the chimney that is resistant to the wind,

the possibility of securing the external air supply and the size of the necessary openings,

Simultaneous use of stove that needs to be connected with other equipment that already exists
at that place.
If the results of all checks are positive, then we can proceed with connecting the stove. Make sure you
follow the instructions of the manufacturer of the stove, as well as the standards for fire protection and the
safety standards provided.
When you are finished connecting, the stove has to be turned on in trial mode for at least 30 minutes to test
if the stove is working properly.
When the installation and important details are completed, the installer must provide the client the following:

Instructions for use and maintenance issued by the manufacturer of the stove (if such instructions
are not provided with the stove),

The documentation necessary to comply with the existing standards.
4. INSTALLATION
– STOVE INSTALLATION
Responsibility for the work carried out at the place of connection is entirely on the user.
Before one turns the stove on, the installer must meet all legal standards of safety, as well as the following
requirements:

to check that setting up the stove complies with local, national, and European regulations,

that the location of setting up the stove meets the requirements set forth in this manual,

to set up the flue pipes,

that air intake matches the type of the installed stove,

that the electrical connections are not set up using temporary and/or not insulated electrical cables,

to evaluate the effectiveness of grounding electrical systems,

to always use personal protective equipment and all means of protection that are prescribed by local
regulations,

to always provide sufficient service space required for any maintenance and repair of stoves
4.1 INSTALLING THE STOVE
We recommend you to unpack the stove only when the stove is set up in the position where it will be
connected.