golmar NEXA Series, Руководство пользователя

Страница: 136 / 146

With the handset lifted:
If programming the monitor as master, replace the handset.
If programming it as slave, press the door release push button, then replace the
handset.
Master Slave
IMPORTANT:
If the installation has a CD-PLUS/R5 converter with coded panel or guard unit, the programming codes assigned to the
monitors must be between 1 and 250. To make it easier for the user to make a call, another parallel code can be assigned
in a 2nd assignment table.
Turn off the monitor to be programmed by holding pressed the door release push button for
one second.
Once off, press the auto switch-on button.
While holding pressed the auto switch-on button, simultaneously press the door release
button.
To show that the system is ready for programming, the door panel will emit a tone and the
image will appear on the monitor. The push buttons can now be released.
Lift the handset off the monitor.
Enter the code to be called by this monitor and press bell.
At this moment both door panel and handset will emit tones.
Each apartment must only have one master unit; if there are parallel units, whether monitors or telephones, they must be
configured as slaves.
Make a call to check that the monitor has been successfully programmed. Programme the other
monitors in the same way.
After programming, press button C.
Programming Tekna R5 monitors: Col SU-R5
PROGRAMMING THE MONITORS
136
To enter con fi guration mode, press the key button
three times and then enter the secret administrator
pin (factory code 2718) as described on p. 1
. 17
CONFIGURATION
2 7 1 8
****
0 1
0 1
AUDIO AND VIDEO DOOR ENTRY SYSTEM - CODED PANEL WITH DISPLAY
(1)
Bear in mind the number of digits in the configured code (factory setting 2718 = 4). (1)
rogramming from coded module:
Important:
Enter p
- With EL632 sound module V0 or later R5 1 / EL632 R5 P/T with V03 or later.
- With N3301/AL or NX3301 V03 or later. access control module
- N3403/AL NX3403 V05 y posterior. With or display module