golmar NEXA Series, Руководство пользователя

Страница: 46 / 146

Programming Tekna Plus monitors from a general entrance door panel (SW1-1 ON): SE
PROGRAMMING THE MONITORS - GENERAL ENTRANCE DOOR PANEL ONLY
To programme the monitor from a inner door panel, see p. 4 . 5
46
Locate the SW2 DIP switch on the general entrance door panel situated on the top left-hand
side of the back of the sound module. With switch 1 OFF and switch 3 ON, set switch 2 to ON:
the general entrance door panel will emit a tone indicating that it has entered programming
mode.
In systems with more than one door panel, only carry out this procedure on the main door panel.
Important:
. To perform this programming, the monitor's SW2 DIP switches should be set to
OFF
AUDIO AND VIDEO DOOR ENTRY SYSTEM - ACCESS CONTROL
Switch off the monitor to be programmed One long press for 3 seconds, turns the monitor (
O O ) n or ff . Once the telephone is off, press the door release push button.
With the door release push button pressed, switch on the monitor.
To show that the system is ready for programming, the door panel will reproduce a sound
and the picture will appears on the monitor. At this moment, the door release push button
can be released. Lift the handset to establish audio communication with the door panel.
Press the door panel push button that will call this monitor.
At this moment the door panel will reproduce a sound and the monitor led will
blink
. red
Each apartment must only have one master unit; if there are parallel units, whether monitors or telephones, they must be
configured as slaves.
Make a call to check that the monitor has been successfully programmed. Programme the other
telephones in the same way.
Once the programming has finished, set the programming switch to OFF. If this is not done, the door
panel will emit tones to indicate that the system is still in programming mode.
P
S
SI
SV
To programme the monitor as , press button once, and the status LED will blink
Slave
1
green once. Continue successively to , pressing button four times, with the status Slave 4
LED blinking green four times.
To programme the monitor as , press button and the status LED will blink Slave with intercom
green once.
To programme the monitor as , press button for 3 seconds
Master
.
To programme the monitor as , press button and the status LED will blink
Slave without video
green once. If button is pressed again, the monitor will return to being programmed as
Slave
with video
, and the status LED will blink green twice. The door panel video will be displayed
during a call depending on whether the monitor has been programmed as: Slave with video or
Slave without video.