•Page
globalcontract.com
23
• Summer 2017
GLOBAL
Contract
Ensure that all panels are leveled and securely connected before proceeding with
installation of worksurfaces supports.
STEP 1: Align the fi rst bracket’s edge with pedestal’s top corner and rear vertical edge
as illustrated.
STEP 2: Secure the top bracket with supplied, self-drilling, counter-sunk head screws.
STEP 3: Align the second bracket’s bottom edge with pedestal’s bottom corner and
rear vertical edge and secure it with supplied, self-drilling, countersunk head screws.
(Not shown).
STEP 4: Angle the pedestal on the fl oor and insert bracket ends into panel’s vertical
side groove.
STEP 5: Rotate the pedestal while making sure that both brackets remain securely
engaged inside the panel’s vertical side groove. Install worksurface support on the
opposite side of the worksurface as specifi ed. Rest worksurface on both supports.
STEP 6: Adjust pedestal’s levelers to level the worksurface and ensure that the pedes-
tal’s side is perpendicular to the panel.
NOTE: Read before you proceed with the next step! If you use a full depth pedestals
( 24” deep pedestal under 24” deep worksurface) to secure worksurfaces to a panel
with optional Panel cable manager, do not bolt the pedestal to the worksurface yet.
You may have to angle and slide the pedestal partially out in order to gain an access
to the panel’s cable manager. In this case, the following step (#7) should be done at
the end of the installation, after all cables had been tucked away in the Panel cable
manager.
STEP 7: Remove drawers, pre-drill the pedestal top and drive two wood screws
through the pedestal top, into the worksurface. Replace the drawers and secure the
opposite side of the worksurface to its support.
CORNER PLATE
STEP 1: Position corner plate on already installed and secured worksurfaces so
that the corners plate is aligned with a line between two adjacent
worksurfaces.
STEP 2: Drive two wood screws through holes in the the bottom fl ange of the
corner plate.
TOP
BRACKET
BOTTOM
BRACKET
Pedestal Bracket / Corner Plate
INSTALLATION GUIDELINES
1
2
4
5
6
7
1
2
