Gira 2617 Series, Руководство по эксплуатации

Страница: 27 / 52

27
27
IV
Setting switching time of relays
The contact hold time of both relays can be set from 3 to
30 seconds.
Start mode:
1. Lay the programming finger on until a short acknowl-
edgement tone is heard.
3 The LED briefly lights up green, then flashes orange.
2. Lay the programming finger on until a short acknowl-
edgement tone is heard.
3 The LED briefly lights up green, then flashes orange
twice.
3. Lay the administrator finger on until a short acknowl-
edgement tone is heard.
3 The LED briefly lights up green, then orange.
Set contact hold time:
4. Lay on any finger to start switching time.
3 The fingerprint reader generates an acknowledgement
tone every second, the LED simultaneously flashes
green. The relays are not activated during setting of the
switching time.
5. To end setting of the switching time, lay on any finger
again.
3 The fingerprint reader generates a positive acknowl-
edgement signal: the switching time was successfully
set.
Progr. Progr. Admin User Switching time User