Gima GIMAled81, Инструкция по эксплуатации

Страница: 78 / 114

INSTALLATION
MANUAL
EN
MI_020 Rev.1 29/04/2020 Page 21 of 24
4.4.2 Installation of swinging arm
Position the swinging arm (1) in front of the stem and in
correspondence with the pivot (2).
Match the threaded hole of pivot (3) with the hole located on the
hub (4).
Insert the swinging arm (1) into the pivot (2) and fastening it by
tightening the screw (5).
Insert the plastic cover (6) from the bottom, widening it if required
to make insertion easier. Fasten the cover by inserting the fasteners
in the hub recesses.
Join the wiring connectors and fasten the upper cover (7) with the
screw (8).
Position the cover (9) and secure it with the screw (10) in line with
the threaded hole.
4.4.3 Installation of cupola
See point 4.3.4 above.
4.4.4 Electrical connection
Lift the closing ring (1) and the stand cover (2) by 30-40 cm in order
to access the power section. Join the connectors coming from the
stem and switch. Return the cover and seal to original position and
faster the cover (2) by means of the screws (3) to be fastened to
the threaded bush (4). In the case of a battery lamp, also connect
the battery faston that is disconnected.
After making the connection, engage the fuses.
The Product power connection is by means of a plug integrated in
the supply cable supplied with the Product, placed on the box.