Gima GIMAled81, Инструкция по эксплуатации

Страница: 76 / 114

INSTALLATION
MANUAL
EN
MI_020 Rev.1 29/04/2020 Page 19 of 24
Comply with the line and neutral
connection indications. An
inverted connection would lead to
the lack of fuse protection.
Connect the wires (red and black) to the 3 and 4 terminals in case
of single light head lamps and in case of double light head lamps
to the terminals 5 and 6, 7 and 8. Follow always the colors and
numbers on cables and terminals.
Failure to connect the earth
cables would prevent the safety
of the Product.
Strictly follow the wiring diagram
for the correct connection.
Always connect earthing cables ( ) of lamp and net into the
related terminals.
Out of every lamp there is always a communication cable (OW)
connected to a forbox. In case of double light head lamp the cables
(OW) of both lamps are connected to the same forbox.
This OW cable is needed for the communication between the lamps
and to the optional wall control.
The cable (OW) of the wall control panel (if supplied) has to be
connected to the forbox in order to allow the communication.
If the lamp isn’t equipped with wall control panel, do not consider
forbox connection
4.3.6 Installation of ceiling cover
Once the electrical connections have been completed, the
installation can be completed by positioning the ceiling cover.
Depending on the type of ceiling (with false ceiling or not), a cover
is provided split into two halves, which can be high or low.
To install, position the two halves (1) in line with the ceiling anchoring
tube. Close them by tightening the two screws of the ring (2) and
the 4 screws of the cover (3).
Fasten the ring earth lead in the respective terminal.
Bring the complete cover (4) up against the ceiling / false ceiling
and secure it in position by fully tightening the 4 screws (5).