Gima GIMAled81, Инструкция по эксплуатации

Страница: 108 / 114

OPERATION AND
MAINTENANCE MANUAL
EN
MU_027 Rev.1 29/04/2020 Page 27 of 33
10 EMC Declaration
The Product has been tested according to EN60601-1-2 standard to
ensure correct electromagnetic compatibility.
Possibility of interferences with
nearby appliances.
Portable and mobile communication appliances can affect the
Product. The product should not be used close to another device
and if this is inevitable, the product must be checked to make sure
it is working properly.
The use of accessories other than those supplied/recommended by
the manufacturer could increase the level of emissions and lower
the level of immunity of the appliance.
The Product has been designed to be used in the electromagnetic
environments described below.
The Responsible Organization or Operator is responsible for making
sure the Product is used in a compatible environment.
It could occur that if the Product is affected by radiations in the
range of 80 MHz – 1 GHz or bursts, it will no longer respond to the
commands both as regards the lamp and the camera.
If this does occur, essential performance will in any case be ensured,
but to restore normal operation it will be necessary to de-energize
the master switch.
Immunity test Compliance Electromagnetic environment - directives
RF Emissions
CISPR 11
Group 1
The Product only uses RF energy for internal operation.
Consequently its RF emissions are very low and should not cause
any interference to nearby electronic appliances.
RF Emissions
CISPR 11
Class A
The Product is suitable for use in all environments except in
domestic environments and those directly connected to a low-
voltage public mains supply which supplies buildings used for
domestic purposes, as long as the following precaution is followed.
Warning:
This Product is intended for use by professional health
personnel only. This Product can cause radio-interference or disturb
the operation of nearby appliances. Measures may have to be
taken to reduce such disturbance, such as Product re-positioning
or shielding of premises.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations
/flicker emissions
IEC 61000-3-3
Conforming
NOTE: The EMISSIONS characteristics of this equipment make it suitable for use in industrial areas and hospitals (CISPR
11 class A). If it is used in a residential environment (for which CISPR 11 class B is normally required) this equipment might
not offer adequate protection to radio-frequency communication services. The user might need to take mitigation
measures, such as relocating or re-orienting the equipment.