Gima GIMAled81, Инструкция по эксплуатации

Страница: 98 / 114

OPERATION AND
MAINTENANCE MANUAL
EN
MU_027 Rev.1 29/04/2020 Page 17 of 33
Afterwards wipe the product with the cloth.
Failure to comply with the above instructions could cause:
-
detaching of paint with possible accidental dropping of such
paint into the patient area;
-
early ageing of the plastic parts with consequent weakening
and the possibility of breakages;
-
tarnishing of the protection screens and glass.
6.2 Cleaning the Product
Frequency We recommend you to clean the Product every day.
Possibility of damaging the
Product.
-
Do not use sharp, pointed or abrasive objects, to avoid the risk
of damaging surfaces.
-
Do not pour liquids directly on the Product.
-
Clean the Product with a damp, but not wet, cloth.
-
Clean with suitable detergents with low alkaline content and
chlorine free. Do not use abrasive products, petrol, paint
thinners, alkaline detergents, acids, containing alcohol or
aldehydes.
-
Dose the detergents strictly according to the percentage
indications shown on the manufacturer’s technical sheet, being
careful that no liquids penetrate into the joints of the various
Product parts, with special care give to the reflector and
supporting structure.
6.3 Product disinfecting
Frequency We recommend you to disinfect the Product every time before use.
Possibility of damaging the
Product.
Disinfectants can contain substances that are harmful for the
health; use disinfectants indicated by the national commission for
hygiene and disinfection, according to the hygienic standards
adopted by the Responsible Organization.
-
Do not use sharp, pointed or abrasive objects, to avoid the risk
of damaging surfaces.
-
Do not pour liquids directly on the Product.
-
Disinfect the Product with a damp but not wet cloth.
-
Use appropriate disinfectants with low alcohol content.
-
To prevent damaging the stainless-steel and aluminium parts,
use only disinfectants that do not contain chlorine or halogens.
-
Dilute the disinfectants in strict accordance with the percentage
indications on the manufacturer’s technical data sheet, being
careful no liquids penetrate into the joints of the various parts of
the Product, with special attention for the reflector and
supporting structures.