GILES FSH-2-PH, Руководство пользователя

Страница: 16 / 66

6
Installation
FSH − 2 − PH
2.02 Unpacking
IMPORTANT !!
When received, if the load exhibited any sign of damage, the equipment and all included accessories should have
been immediately inspected, and the freight company promptly notified of any damages.
Typically, it will be the
purchaser’s responsibility to report & negotiate freight damage claims .
Unit is shipped on a wooden pallet, secured with high ­ tensile plastic strapping and wrapped with plastic stretch
film. A wooden framework is built around the unit for added protection. Unpack unit as follows:
1. Position pallet in an area that will provide adequate space for uncrating.
2. Remove stretch film wrap, strapping and any other packaging materials.
3. Carefully remove wooden crating framework, as necessary.
4. Locate the separate carton containing a 1 ‐ 1/2 gal. wet chemical fire suppressant tank and secure for safe
keeping ... it will be needed by the Ansul Technician during field set ­ up of the fire suppression system.
5. To avoid damage, the unit was shipped without the leveling legs installed. They are packed in a separate carton.
Be sure to retain for installation, see Adjustable Leg Installation below.
6. Carefully remove the unit from the shipping pallet. The hood is very heavy and also top ­ heavy, see Section 1.06,
Unit Weight . Great care should be taken when lifting or moving the unit to avoid personal injury or equipment
damage.
•
The hood is heavy and also top ­ heavy, which will present a tipping hazard! Exercise due caution when handling
to avoid personal injury or damage to the equipment. After hood legs are attached, use due care to avoid
bending or otherwise damaging them.
•
Exercise care when removing the protective wooden framework from around the unit to avoid exposed nails or
staples.
•
Failure to comply with these CAUTION notices may result in minor to moderate injury, damage to equipment or
property, and void the warranty.
1. Obtain carton containing the adjustable leveling legs.
2. With appliance resting on a stable surface, have two helpers tilt the unit forward slightly and hold. For
safety, carefully brace the tilted unit with a suitable length wooden board while it is tilted.
3. Apply a suitable thread ­ lock, (such as Red Loctite), to the male threads on the leg.
4. Screw two (2) legs into threaded holes on bottom of the hood stand sides ... turning clockwise, hand tighten
only. Take care not to cross ‐ thread ... legs should turn fairly easy until tight.
5. Have helpers tilt unit, onto the installed legs, in the other direction, taking same precautions, to gain access
to the other threaded holes and repeat the process with the other two (2) legs .
Adjustable Leg Installation