GILBARCO VEEDER-ROOT FlexPay IV CRIND, Руководство по установке

Страница: 25 / 66

21
SECTION 4 - INSTALLATION
4
MDE-5222F
DCM2 Assembly
To connect the cables:
1 Connect J302A/B of M15242A001 to P302B of DCM2.
2 If M15241AXXX is provided, connect J315 on the cable to P315 on the DCM2 and connect J111 on the
cable to the “PC Serial Connection” or P1111 on the PCN. (This PCN connection is the same as the one
used for software updates.)
DCM2 Connectors
The following table lists the port numbers and functions of DCM2 connectors:
DCM2 Connector Port Number Function
3-pin MTA .156” P301 24 VDC power input
2-pin MTA .156” P306A 24 VDC power output (fused). This is primarily
used to power the DCM in Applause Media
System.
2-pin MTA .156” P306B 24 VDC power output (fused)
5-pin MTA .100” P300 Two-wire from Distribution Box

(D-Box) [CRIND and Pump (Generic only)].
5-pin MTA .100” P315 Insite360 Encore connection to PCN
2-pin MTA .100” P303 Two-wire connection to PCN
8-pin MTA .100” P302A RS-232 pump and CRIND to PIP3 A
8-pin MTA .100” P302B RS-232 pump and CRIND to PIP3 B
RJ-45
P304A/B Ethernet connection to the back room. P304B
is the optional discreet wire connection.
J305C Ethernet connection to UPM Side A
J310A UX300A
J310B Ethernet connection to UPM Side B
J303B UX300B
J310A Laptop Service port
J303A
DCM2 Jumper
The following table lists the status and functions of jumper:
On Off Function
J3 x High-speed connection over two-wire active cable. P304 A/B disabled.
x High-speed connection over two-wire inactive cable. P304A and P304B connects to
Category 5 (CAT5) cable running through the conduit for high speed connection

(if used).
J4 x Unit is connected to a Passport Point of Sale [POS (MOC)]
x Unit is connected to a third-party POS (Generic)