GILBARCO VEEDER-ROOT FlexPay IV CRIND, Руководство по установке

Страница: 13 / 66

9
SECTION 3 - REMOVING COMPONENTS
3
MDE-5222F
Door Node
To remove the door node:
1
Remove the soft keypad connector (P2106) from the door node (see Figure 1 ).
Figure 1: Removing Door Node
These can be removed
2
Remove the push-to-start connector from P2111 on the door node.
3
Disconnect and remove the J5 (24 V power cable) connector from the monochrome display.
4
Disconnect and remove the CN2 connector from the old card reader.
5
Disconnect and remove the customer keypad connector from the keypad.
6
If the call button is installed, remove J902C from the call button board. This will be replaced by a new
cable provided in the kit.
7
Remove the door node by removing the four screws that secure it to the unit door.
Note: Retain the door node and screws for reinstallation. Place all the boards in a safe and static-free
surface.
Printer
Remove the printer assembly from the old door only if it is required to be installed on the new door.