Gewiss Chorus GW 10 764H, Руководство по программированию

Страница: 31 / 40

E
N
G
L
I
S
H
31
To personalise the hourly profile program of the device, call up the main page of the timed thermostat
or the general hourly timer profile (make sure the profiles have been enabled with Easy controller),
then press the
button key twice. You will see the word PROG on the screen. To quit the
programming procedure without saving any modifications made to the current page, just press the
button key again or wait 30 seconds from the last pressure on the button keys. The parameters
that can be modified will depend on the page you are viewing in normal operation status: if the visible
page relates to the timed thermostat, the Prog menu concerning the timed thermostat will be shown;
if the visible page is that of a general hourly timer profile, the Prog menu concerning the selected
profile will be shown.
Access to the Prog menu is indicated by the word PROG on the
display, and by the flashing of the day of the week. Set the day by
means of the
button keys (MON, TUE, WED, THU, FRI, SAT,
SUN). To confirm your choice and move on to the next parameter,
press the
button key within 30 seconds.
After confirming the day, the display will show the current profile
for that day. The time will start flashing.
To customise the time setting, you must:
- select the temperature variation start time
- set the new temperature setpoint
- complete the customisation
Selecting the temperature variation start time
Use the or button key to modify the time band in which you
want to vary the set profile: while you are selecting the hourly
profile, the column relating to the selected time will flash. The time
band is decreased/increased by 15-minute steps each time the
or
button key is pressed: you can therefore obtain up to 4
programming periods in each hour. To confirm your choice and move
on to the next parameter, press the
button key within 30 seconds.
Setting the new setpoint (TEMP)/Value (VAL)
The value corresponding to the current setpoint/value will be shown
on the display by flashing spots
, , (if the profile
relates to the timed thermostat) or by VAL, , , ,
, (if the profile relates to the hourly timer). Keep the
or button
key pressed to select the new setpoint/value (visible in the top right
corner of the screen) that will be applied to the hourly profile until the
next variation in the program. To confirm your choice and return to
the time selection, press the
button key within 30 seconds.
Hourly profile programming
USER INSTRUCTIONS